Dell Force10 S4810P S4810 Configuration Guide, FTOS 8.3.10.1 - Page 982

www.dell.com | support.dell.com Task Command Syntax Command Mode Save the stacking configuration on the ports. write memory EXEC Privilege Reload the switch. FTOS automatically assigns a number to the new unit and adds it as member switch in the stack. The new unit synchronizes its running and startup configurations with the stack. reload EXEC Privilege After the units are reloaded, the system reboots. The units come up in a stack after the reboot completes. Creating a New Stack Prior to creating a stack, know which unit will be the management unit and which will be the standby unit. You must also enable the front ports of the units for stacking. For more information, see"Enable Front End Port Stacking" on page 981. To create a new stack: Step 1 2 3 Task Command Syntax Power up all units in the stack Verify that each unit has the same FTOS version show version prior to stacking them together. Manually configure unit numbers for each unit, so that the stacking is deterministic upon boot up. Renumbering will cause the unit to reboot. The stack-unit default for all new units is stack-unit 0. stack-unit 0 renumber Command Mode EXEC Privilege EXEC Privilege 982 | Stacking