Dell Force10 S4810P S4810 Configuration Guide, FTOS 8.3.10.1 - Page 70

www.dell.com | support.dell.com Step 9 10 11 Task Save the running-config. Set the system parameters to use the startup configuration file when the system reloads. Save the running-config. Command Syntax copy running-config startup-config setenv stconfigignore false copy running-config startup-config Command Mode EXEC Privilege uBoot EXEC Privilege Recovering from a Forgotten Enable Password on the S4810 If you forget the enable password: Step 1 2 3 4 5 6 7 Task Command Syntax Command Mode Log onto the system via console. Power-cycle the chassis by switching off all of the power modules and then switching them back on. Hit any key to abort the boot process. hit any key You enter uBoot immediately, as indicated by the => prompt. Set the system parameters to ignore setenv enablepwdignore true the enable password when the system reloads. Reload the system. reset (during bootup) uBoot uBoot Configure a new enable password. Save the running-config to the startup-config. enable {secret | password} copy running-config startup-config CONFIGURATION EXEC Privilege Recovering from a Failed Start on the S4810 A system that does not start correctly might be attempting to boot from a corrupted FTOS image or from a mis-specified location. In that case, you can restart the system and interrupt the boot process to point the system to another boot location. Use the setenv command, as described below. For details on the setenv command, its supporting commands, and other commands that can help recover from a failed start, see the Boot User chapter in the FTOS Command Line Reference for the S4810. Step Task Command Syntax 1 Power-cycle the chassis (pull the power cord and reinsert it). 2 Hit any key to abort the boot process. hit any key You enter uBoot immediately, as indicated by the => prompt. Command Mode (during bootup) 70 | Management