Dell Force10 S4810P S4810 Configuration Guide, FTOS 8.3.10.1 - Page 25

MAC Addressing on S-Series Stacks 974 Stacking LAG 976 Supported Stacking Topologies 976 High Availability on S-Series Stacks 977 Management Access on S-Series Stacks 978 Important Points to Remember - S4810 Stacking 979 S-Series Stacking Installation Tasks 980 Create an S-Series Stack 980 Add Units to an Existing S-Series Stack 985 Split an S-Series Stack 989 S-Series Stacking Configuration Tasks 989 Assign Unit Numbers to Units in an S-Series Stack 989 Create a Virtual Stack Unit on an S-Series Stack 990 Display Information about an S-Series Stack 990 Influence Management Unit Selection on an S-Series Stack 992 Manage Redundancy on an S-Series Stack 993 Reset a Unit on an S-Series Stack 993 Verifying a Stack Configuration 993 LED Status Indicators on an S4810 Stack 993 Display Status of Stacking Ports 994 Removing Units or Front End Ports from a Stack 995 Remove a Unit from an S-Series Stack 995 Remove Front End Port Stacking 996 Troubleshoot an S-Series Stack 997 Recover from Stack Link Flaps 997 Recover from a Card Problem State on an S-Series Stack 997 Recover from a Card Mismatch State on an S-Series Stack 999 48 Storm Control 1001 Configure Storm Control 1001 Configure storm control from INTERFACE mode 1001 Configure storm control from CONFIGURATION mode 1002 49 Spanning Tree Protocol (STP 1003 Protocol Overview 1003 Configuring Spanning Tree 1003 Related Configuration Tasks 1003 Important Points to Remember 1004 Configuring Interfaces for Layer 2 Mode 1004 Enabling Spanning Tree Protocol Globally 1006 Adding an Interface to the Spanning Tree Group 1008 Removing an Interface from the Spanning Tree Group 1008 Modifying Global Parameters 1009 | 25