Dell Force10 Z9000 FTOS Configuration Guide for Z9000 System - Page 108

www.dell.com | support.dell.com Figure 6-12. Applying an ACL to the Loopback Interface FTOS(conf)#interface loopback 0 FTOS(conf-if-lo-0)#ip access-group abcd in FTOS(conf-if-lo-0)#show config ! interface Loopback 0 no ip address ip access-group abcd in no shutdown FTOS(conf-if-lo-0)#end FTOS#configure terminal FTOS(conf)#ip access-list extended abcd FTOS(config-ext-nacl)#permit tcp any any FTOS(config-ext-nacl)#deny icmp any any FTOS(config-ext-nacl)#permit 1.1.1.2 FTOS(config-ext-nacl)#end FTOS#show ip accounting access-list ! Extended Ingress IP access list abcd on Loopback 0 seq 5 permit tcp any any seq 10 deny icmp any any seq 10 deny icmp any any Use the in keyword. Add rules to the ACL named "abcd." Display the ACL. Note: See also the section VTY Line Local Authentication and Authorization. IP Prefix Lists c e s z Prefix Lists are supported on platforms: IP prefix lists control routing policy. An IP prefix list is a series of sequential filters that contain a matching criterion (examine IP route prefix) and an action (permit or deny) to process routes. The filters are processed in sequence so that if a route prefix does not match the criterion in the first filter, the second filter (if configured) is applied. When the route prefix matches a filter, FTOS drops or forwards the packet based on the filter's designated action. If the route prefix does not match any of the filters in the prefix list, the route is dropped (that is, implicit deny). A route prefix is an IP address pattern that matches on bits within the IP address. The format of a route prefix is A.B.C.D/X where A.B.C.D is a dotted-decimal address and /X is the number of bits that should be matched of the dotted decimal address. For example, in 112.24.0.0/16, the first 16 bits of the address 112.24.0.0 match all addresses between 112.24.0.0 to 112.24.255.255. Below are some examples that permit or deny filters for specific routes using the le and ge parameters, where x.x.x.x/x represents a route prefix: • To deny only /8 prefixes, enter deny x.x.x.x/x ge 8 le 8 • To permit routes with the mask greater than /8 but less than /12, enter permit x.x.x.x/x ge 8 le 12 • To deny routes with a mask less than /24, enter deny x.x.x.x/x le 24 • To permit routes with a mask greater than /20, enter permit x.x.x.x/x ge 20 108 | Access Control Lists (ACLs)