Dell Force10 Z9000 FTOS Configuration Guide for Z9000 System - Page 185

Figure 8-13. Command example: show ip bgp summary (4-Byte AS Number displayed) R2#show ip bgp summary BGP router identifier 192.168.10.2, local AS number 48735.59224 BGP table version is 1, main routing table version 1 1 network entrie(s) using 132 bytes of memory 1 paths using 72 bytes of memory BGP-RIB over all using 73 bytes of memory 1 BGP path attribute entrie(s) using 72 bytes of memory 1 BGP AS-PATH entrie(s) using 47 bytes of memory 5 neighbor(s) using 23520 bytes of memory 4-Byte AS Number Neighbor AS MsgRcvd MsgSent TblVer InQ OutQ Up/Down State/Pfx 10.10.21.1 10.10.32.3 100.10.92.9 192.168.10.1 192.168.12.2 R2# 65123 65123 65192 65123 65123 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 never 0 never 0 never 0 never 0 never Active Active Active Active Active For the router's identifier, FTOS uses the highest IP address of the Loopback interfaces configured. Since Loopback interfaces are virtual, they cannot go down, thus preventing changes in the router ID. If no Loopback interfaces are configured, the highest IP address of any interface is used as the router ID. To view the status of BGP neighbors, use the show ip bgp neighbors (Figure 8-14) command in EXEC Privilege mode. For BGP neighbor configuration information, use the show running-config bgp command in EXEC Privilege mode (Figure 8-15). Note that the showconfig command in CONFIGURATION ROUTER BGP mode gives the same information as thew show running-config bgp. Figure 8-14 displays two neighbors, one is an external and the second one is an internal BGP neighbor. The first line of the output for each neighbor displays the AS number and states whether the link is an external or internal. The third line of the show ip bgp neighbors output contains the BGP State. If anything other than ESTABLISHED is listed, the neighbor is not exchanging information and routes. For more details on using the show ip bgp neighbors command, refer to the FTOS Command Line Interface Reference. Border Gateway Protocol | 185