Dell Force10 Z9000 FTOS Configuration Guide for Z9000 System - Page 31

Figure 2-2. CLI Modes in FTOS EXEC EXEC Privilege CONFIGURATION ARCHIVE AS-PATH ACL INTERFACE GIGABIT ETHERNET 10 GIGABIT ETHERNET INTERFACE RANGE LOOPBACK MANAGEMENT ETHERNET NULL PORT-CHANNEL SONET VLAN VRRP IP IPv6 IP COMMUNITY-LIST IP ACCESS-LIST STANDARD ACCESS-LIST EXTENDED ACCESS-LIST LINE AUXILIARY CONSOLE VIRTUAL TERMINAL MAC ACCESS-LIST MONITOR SESSION MULTIPLE SPANNING TREE OPENFLOW Per-VLAN SPANNING TREE PREFIX-LIST RAPID SPANNING TREE REDIRECT ROUTE-MAP ROUTER BGP ROUTER ISIS ROUTER OSPF ROUTER RIP SPANNING TREE TRACE-LIST Navigating CLI Modes The FTOS prompt changes to indicate the CLI mode. Table 2-1 lists the CLI mode, its prompt, and information on how to access and exit this CLI mode. You must move linearly through the command modes, with the exception of the end command which takes you directly to EXEC Privilege mode; the exit command moves you up one command mode level. Note: Sub-CONFIGURATION modes all have the letters "conf" in the prompt with additional modifiers to identify the mode and slot/port information. These are shown in Table 2-1. Configuration Fundamentals | 31