Dell Force10 Z9000 FTOS Configuration Guide for Z9000 System - Page 117

To view the configuration, use the show config command in the ROUTE-MAP mode (Figure 6-21). Figure 6-21. Command Example: show config in the ROUTE-MAP Mode FTOS(config-route-map)#show config ! route-map dilling permit 10 FTOS(config-route-map)# You can create multiple instances of this route map by using the sequence number option to place the route maps in the correct order. FTOS processes the route maps with the lowest sequence number first. When a configured route map is applied to a command, like redistribute, traffic passes through all instances of that route map until a match is found. Figure 6-22 shows an example with two instances of a route map. Figure 6-22. Command Example: show route-map with Multiple Instances of a Route Map FTOS#show route-map route-map zakho, permit, sequence 10 Match clauses: Set clauses: route-map zakho, permit, sequence 20 Match clauses: interface GigabitEthernet 0/1 Set clauses: tag 35 level stub-area FTOS# Route map zakho has two instances To delete all instances of that route map, use the no route-map map-name command. To delete just one instance, add the sequence number to the command syntax (Figure 6-23). Figure 6-23. Deleting One Instance of a Route Map FTOS(conf)#no route-map zakho 10 FTOS(conf)#end FTOS#show route-map route-map zakho, permit, sequence 20 Match clauses: interface GigabitEthernet 0/1 Set clauses: tag 35 level stub-area FTOS# Figure 6-24 shows an example of a route map with multiple instances. The show config command displays only the configuration of the current route map instance. To view all instances of a specific route map, use the show route-map command. Access Control Lists (ACLs) | 117