Dell Force10 Z9000 FTOS Configuration Guide for Z9000 System - Page 647

Figure 29-17. Command Example: show run ospf FTOS#show run ospf ! router ospf 1 graceful-restart grace-period 300 graceful-restart role helper-only graceful-restart mode unplanned-only graceful-restart helper-reject 10.1.1.1 graceful-restart helper-reject 20.1.1.1 network 10.0.2.0/24 area 0 FTOS# Use the following command to disable OSPFv2 graceful-restart after you have enabled it. Command Syntax no graceful-restart grace-period Command Mode Usage CONFIG-ROUTER- Disable OSPFv2 graceful-restart. Returns OSPF OSPF-id graceful-restart to its default state. For more information on OSPF graceful restart, refer to the FTOS Command Line Interface Reference Guide. Filter routes To filter routes, use prefix lists. OSPF applies prefix lists to incoming or outgoing routes. Incoming routes must meet the conditions of the prefix lists. If they do not, OSPF does not add the route to the routing table. Configure the prefix list in CONFIGURATION PREFIX LIST mode prior to assigning it to the OSPF process. Command Syntax Command Mode Usage ip prefix-list prefix-name CONFIGURATION Create a prefix list and assign it a unique name. You are in PREFIX LIST mode. seq sequence-number {deny |permit} ip-prefix CONFIG- PREFIX [ge min-prefix-length] [le max-prefix-length] LIST Create a prefix list with a sequence. number and a deny or permit action. The optional parameters are: ge min-prefix-length: is the minimum prefix length to be matched (0 to 32). le max-prefix-length: is the maximum prefix length to be matched (0 to 32). For configuration information on prefix lists, refer to the Access Control Lists (ACLs) chapter in the FTOS Configuration Guide. Open Shortest Path First (OSPFv2 and OSPFv3) | 647