Dell Force10 Z9000 FTOS Configuration Guide for Z9000 System - Page 54

www.dell.com | support.dell.com Create a Custom Privilege Level FTOS(conf)#do show run priv ! privilege exec level 3 capture privilege exec level 3 configure privilege exec level 4 resequence privilege exec level 3 capture bgp-pdu privilege exec level 3 capture bgp-pdu max-buffer-size privilege configure level 3 line privilege configure level 3 interface FTOS(conf)#do telnet 10.11.80.201 [telnet output omitted] FTOS#show priv Current privilege level is 3. FTOS#? capture Capture packet configure Configuring from terminal disable Turn off privileged commands enable Turn on privileged commands exit Exit from the EXEC ip Global IP subcommands monitor Monitoring feature mtrace Trace reverse multicast path from destination to source ping Send echo messages quit Exit from the EXEC show Show running system information [output omitted] FTOS#config [output omitted] FTOS(conf)#do show priv Current privilege level is 3. FTOS(conf)#? end Exit from configuration mode exit Exit from configuration mode interface Select an interface to configure line Configure a terminal line linecard Set line card type FTOS(conf)#interface ? fastethernet Fast Ethernet interface gigabitethernet Gigabit Ethernet interface loopback Loopback interface managementethernet Management Ethernet interface null Null interface port-channel Port-channel interface range Configure interface range sonet SONET interface tengigabitethernet TenGigabit Ethernet interface vlan VLAN interface FTOS(conf)#interface gigabitethernet 1/1 FTOS(conf-if-gi-1/1)#? end Exit from configuration mode exit Exit from interface configuration mode FTOS(conf-if-gi-1/1)#exit FTOS(conf)#line ? aux Auxiliary line console Primary terminal line vty Virtual terminal FTOS(conf)#line vty 0 FTOS(config-line-vty)#? exit Exit from line configuration mode FTOS(config-line-vty)# 54 | Management