Dell Force10 Z9000 FTOS Configuration Guide for Z9000 System - Page 804

www.dell.com | support.dell.com SCP is a remote file copy program that works with SSH and is supported by FTOS. Note: The Windows-based WinSCP client software is not supported for secure copying between a PC and an FTOS-based system. Unix-based SCP client software is supported. To use the SSH client, use the following command in the EXEC Privilege mode: Command Syntax Command Mode ssh {hostname} [-l username | -p EXEC Privilege port-number | -v {1 | 2} Purpose Open an SSH connection specifying the hostname, username, port number, and version of the SSH client. hostname is the IP address or hostname of the remote device. • Enter an IPv4 address in dotted decimal format (A.B.C.D). To enable the SSH server for version 1 and 2, use the following command in the CONFIGURATION mode: Command Syntax ip ssh server {enable | port port-number} Command Mode CONFIGURATION Purpose Configure the Dell Force10 system as an SCP/SSH server. To enable the SSH server for version 1 or 2 only, use the following command: Command Syntax ip ssh server version {1|2} Command Mode CONFIGURATION Purpose Configure the Dell Force10 system as an SSH server that uses only version 1 or 2. To view the SSH configuration, use the following command in EXEC Privilege mode: Command Syntax show ip ssh Command Mode Purpose EXEC Privilege Display SSH connection information. Figure 39-6 on page 805 shows the use of the command ip ssh server version 2 to enable SSH version 2, and the show ip ssh command to confirm the setting. 804 | Security