Dell blcwxfg User Guide - Page 189
Installing the Palm Rest, System Board, Removing the System Board
View all Dell blcwxfg manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 189 highlights
1 palm rest 3 touch pad cable-locking arm 2 base 4 touch pad cable Installing the Palm Rest 1 Place the palm rest on top of the base, and engage the snaps around the palm rest edges by pressing with your fingers in a counter-clockwise manner. 2 Turn the Tablet-PC upside down and tighten the eleven M2.5 x 5-mm bottom screws. 3 Turn the Tablet-PC top-side up and tighten the five M2.5 x 5-mm screws labeled with a "P". 4 Connect the touch pad cable to the system board connector. 5 Install any Mini-Cards (see "Installing a Mini-Card" on page 173). 6 Install the keyboard (see "Installing the Keyboard" on page 177). 7 Install the display assembly (see "Installing the Display Assembly" on page 182). 8 Install the hinge cover (see "Installing the Hinge Cover" on page 175). 9 Install the hard drive (see "Installing the Hard Drive" on page 161). System Board CAUTION: Before performing the following procedures, follow the safety instructions in your Product Information Guide. NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching a connector on the back panel of the Tablet-PC. NOTICE: To avoid damaging the system board, you must remove the main battery before you begin working inside the Tablet-PC. Removing the System Board 1 Follow the procedures in "Before You Begin" on page 155. 2 Remove the hinge cover (see "Removing the Hinge Cover" on page 174). Adding and Replacing Parts 189