EMC DS-16B Installation Guide - Page 21
Installing the DS-16B2 Switch, Mounting Bracket Installation
View all EMC DS-16B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Installing the DS-16B2 Switch Installing the DS-16B2 Switch This section describes the procedures for installing the DS-16B2 switch in a rack/cabinet, including attaching the brackets on the switch. Mounting Bracket Installation You must attach mounting brackets to the switch before installing it on the rails. The mounting brackets slide into the "C" channel of the rails. Follow the steps below to attach the mounting brackets to the switch. 1. Orient the L-shaped end of the bracket outward and to the power outlet end of the switch. 2. Place the bracket against the switch. Align the three screw holes in the bracket with the three screw holes on the side of the switch. See Figure 15. 3. Secure the bracket with three 8-32 x 5/16-in pan-head screws (see table on page 8). Tighten the screws fully. #8-32 x 5/16-in. Pan Head Screw Switch (6) Mounting Bracket Hole Figure 15 Attaching the Switch Mounting Brackets Switch Mounting Bracket EMC2048 EMC Departmental Switch DS-16B2 Installation Guide 21