Electrolux E30EW75PPS Complete Owners Guide English - Page 6
Before Setting Oven Controls, Oven Racks, Types of oven racks, Luxury Glide™
View all Electrolux E30EW75PPS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
6 BEFORE SETTING OVEN CONTROLS Oven Vent The oven vent is located under the control panel (Figure 1). When the oven is operational, warm air will pass through this vent for proper air circulation and provide good baking results in the oven. Steam or moisture may appear near the vent, this is normal. Do not block this vent. Types of oven racks Your appliance may be equipped with any one or more of the following rack types. oven vent location flat oven rack flat handle oven rack Figure 1: Oven vent Oven Racks Always use potholders or oven mitts when removing food or adjusting the oven racks. Wait until the oven has completely cooled if possible. Oven racks may be very hot and may cause burns. Removing and replacing flat or offset oven racks • To remove - pull the oven rack straight forward until it reaches the stop position. Lift up front of oven rack slightly and slide out. • To replace - place the oven rack on the rack guides on the oven walls. Tilt the front of the rack upward slightly and slide the oven rack back into place. Flat oven racks may be used for most cooking needs and may be placed in most oven rack positions.(Figure 2) The fully extendable Luxury-Glide™ oven rack (Figure 3) allows you to effortlessly extend your food away from the oven. See Removing and Replacing the Luxury-Glide™ Oven Racks on next page for instructions. Figure 2: Flat rack for most baking Luxury Glide™ Figure 3: Luxury Glide rack IMPORTANT! Do not line oven walls, racks, bottom or any other part of the oven with aluminum foil. Doing so will alter heat distribution, produce poor baking results, and may cause permanent damage to the oven interior. During a self clean cycle oven temperatures will be hot enough to melt foil.