Electrolux E30EW75PPS Complete Owners Guide English - Page 7

Before Setting Oven Controls 7 Installing Oven (Ladder) Rack Supports IMPORTANT! Always install oven rack support before turning on the oven (when the oven is cool). To aid installation of the oven rack supports, apply a thin layer of cooking oil to all the prongs of the supports shown below. Top prong inserts into oven piercing Bottom prong inserts into piercing to make support flush with oven wall Luxury Glide™ oven racks The fully extendable Luxury Glide™ rack makes food preparation easier. This oven rack has glide tracks that allow the rack to be pulled away from the oven without rubbing the sides of the oven wall. The Luxury Glide™ rack installs like all other oven racks. Before sliding the rack all the way in, lift the back of the rack slightly to set the rack past the stop position (Figure 6). Be sure to slide the rack all the way in so that the back of the rack stops by touching the vertical support of the ladder rack. The glide portion of the rack can be easily pulled in and out in this position while the frame of the rack remains locked into the ladder supports. This allows bakeware to remain in place on the Luxury Glide™ rack and slide out easily to check food items without removing them from the oven. . To install oven rack supports: 1. Hold the oven rack support at a slight angle and insert prongs into the holes at the top of the oven cavity (Arrow 1). 2. Lift the rack into the top holes, aligning the bottom prongs with the bottom holes (Arrow 2). 3. Once the upper prongs are in place, hold the oven rack support flush with the oven side and insert the bottom prongs into the bottom holes (Arrow 3). 4. Slide the bottom prongs down into the lower holes. Some force may be required to set the rack into place (Arrow 4). Luxury Glide™ glide stop Figure 5: Glide rack showing glide stop When setting the rack in, the glide stop must be behind the rack support in order for the rack to be properly installed Figure 6: Carefully lift rack while inserting to ensure the glide stop is behind the ladder rack support Figure 4: Follow 4 steps to install ladder racks To remove the ladder rack support for a self-clean cycle, reverse the order used when installing the ladder rack supports.