Epson TM U295 Operation Guide - Page 14
TM-U295, distinguish the two types of screws, see the illustration below; - serial
View all Epson TM U295 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
TM-U295 You need an appropriate serial interface cable to connect your computer to the printer. 1. Make sure that the printer and the computer are turned off. Then plug the cable into the connector on the back of the printer, as shown. Note: Your printer comes with inch-type hexagonal lock screws installed. If you plan to use an interface cable that requires millimeter-type lock screws, replace the inch-type screws with the enclosed millimeter-type screws by using a hex screwdriver (5 mm). To distinguish the two types of screws, see the illustration below; the screw on the right is the millimeter type. TM-T85 / U/G / fig.2-07 95/03/06 NotcChre(sotneec or more lines) Installation 1-3
Installation
1-3
TM-U295
You need an appropriate serial interface cable to connect your
computer to the printer.
1.
Make sure that the printer and the computer are turned off.
Then plug the cable into the connector on the back of the
printer, as shown.
Note:
Your printer comes with inch-type hexagonal lock screws installed.
If you plan to use an interface cable that requires millimeter-type
lock screws, replace the inch-type screws with the enclosed
millimeter-type screws by using a hex screwdriver (5 mm). To
distinguish the two types of screws, see the illustration below; the
screw on the right is the millimeter type.
TM-T85 / U/G / fig.2-07
95/03/06
Crestec
Notch (one or more lines)