Epson TM U295 Operation Guide - Page 59

dx = [dxL + dxH ! 256] dy = [dyL + dyH ! 256] The printable area is set as shown in the figure below. (0, 0) Printable area of the paper (x0, y0) dx dy Printing area (x0+dx-1, y0+dy-1) (209 dots, 479 dots) [Notes] [Default] [Reference] • The maximum printable area in the horizontal direction (x direction) is 210 dots. • The maximum printable area in the vertical direction (y direction) is 480 dots. • If the setting values exceed the printing area, it set to the maximum printing area automatically, depending on the values from xL to dyH. • If (horizontal print starting position + horizontal length) or (vertical print starting position + vertical length) is outside the printable area, the maximum printing area is set to the printable area. • When the print data is buffered in the specified printing area, the length of the printing area in both the horizontal and vertical direction should be 8 dots or more. • The printing area should accommodate to the size of the print sheet. • When the starting point (x0, y0) exceeds the printing area, this command is ignored. • In standard mode, only setting of this command is effective. xL = xH = yL = yH = 0 dxL = 210, dxH = 0, dyL = 224, dyH = 1 CAN, ESC L, ESC T ESC c 3 n [Name] [Format] Select paper sensor(s) to output paper end signals ASCII ESC c 3 n Commands 5-19