Epson TM U295 Operation Guide - Page 55

[Notes] [Default] • Up to 32 tab positions (k = 32) can be set. Data exceeding 32 tab positions is processed as normal data. • When [n]k is less than or equal to the preceding value [n]k-1, tab setting is finished and the following data is processed as normal data. • When [n]k exceeds the number of characters printable on one line, the tab position set is equal to the maximum printable column plus 1. • The previously specified horizontal tab positions do not change, even if the character width changes. • The right-side spacing is set independently in standard and page modes. The horizontal tab setting is set by using amount of the right-side spacing of the mode used. The default tab positions are at intervals of 8 characters (columns 9, 17, 25,...) for the default character font. ESC F n [Name] Set/cancel cut sheet reverse eject [Format] ASCII ESC F n Hex 1B 46 n Decimal 27 70 n [Range] 0 ≤ n ≤ 255 [Description] Sets or cancels the cut sheet reverse eject specified by FF. • When the LSB of n is 0, reverse eject is canceled and forwqrd eject is set. • When the LSB of n is 1, reverse eject is set. [Note] When n cancels reverse eject, this command sets forward ejection automatically. [Default] n = 0 [Reference] FF ESC J n [Name] Print and feed paper [Format] ASCII ESC J n Hex 1B 4A n Decimal 27 74 n [Range] 0 ≤ n ≤ 255 [Description] Prints the data in the print buffer and feeds the paper by n/60 inches. [Note] Sets the print position to the beginning of the line. ESC K n [Name] print and revers feed Commands 5-15