Epson TM U295 Operation Guide - Page 54

[Notes] • The DIP switch settings are not checked again. • The data in the receive buffer is not cleared. • The macro definition is not cleared. ESC C n [Name] Set cut sheet eject length [Format] ASCII ESC C n Hex 1B 43 n Decimal 27 67 n [Range] 0 ≤ n ≤ 127 [Description] Sets the eject length for a cut sheet to n lines. [Notes] [Default] • When n = 0, no eject length is set. • The previously specified eject length does not change, even if the line spacing changes. • This command is available only when FF is executed. n = 0 [Reference] FF ESC D [n] k NUL [Name] Set horizontal tab positions [Format] ASCII ESC D [n] k NUL Hex 1B 44 [n] k 00 Decimal 27 68 [n] k 0 [Range] 1 ≤ n ≤ 255 0 ≤ k ≤ 32 [Description] Sets horizontal tab positions. • n specifies the column number for setting a horizontal tab position from the beginning of the line. • This command cancels the previous horizontal tab settings. • n = column number to be set - 1. When setting n = 8, the print position is moved to column 9 by sending HT. • k indicates the total number of horizontal tab positions to be set. • The horizontal tab position is stored as an absolute value of [character width ! n] measured from the beginning of the line. The character width includes the right-side character spacing, and double-width characters are set with twice the width of normal characters. Also, when character is enlarged in the horizontal direction in page mode, the horizontal position is set as the same way as in standard mode. • Transmit [n]k in ascending order and place a NUL code 0 at the end. • ESC D NUL cancels all horizontal tab positions. An HT received after clearing tabs is ignored. 5-14 Commands