Foxconn Bloodrage GTI English Manual. - Page 25

2 Front Panel Connector : FP1 This motherboard includes one connector for connecting the front panel switch and LED Indicators. Hard Disk LED Connector (HDD-LED) Connect to the chassis front panel IDE indicator LED. It indicates the active status of the hard disks. This 2-pin connector is directional with +/- sign. 12 + + HDD-LED - PWR-LED - RESET-SW PWR-SW NC EMPTY 9 10 FP1 Reset Switch (RESET-SW) Attach the connector to the Reset switch on the front panel of the case; the system will restart when the switch is pressed. Power LED Connector (PWR-LED) Connect to the power LED indicator on the front panel of the chassis. The Power LED indicates the system's status. When the system is in operation (S0 status), the LED is on. When the system gets into sleep mode (S1) , the LED is blinking; When the system is in S3/S4 sleep state or power off mode (S5), the LED is off. This 2-pin connector is directional with +/- sign. Power Switch Connector (PWR-SW) Connect to the power button on the front panel of the chassis. Push this switch allows the system to be turned on and off rather than using the power supply button. 12 1394a Connector : F_1394 TPA+ GND TPAGND The 1394a expansion cable can be connected to either the front TPB+ TPB- (provided that the front panel of your chassis is equipped with +12V +12V the appropriate interface) or real panel of the chassis. EMPTY GND USB Connectors : F_USB1/2 In addition to the eight USB ports on the rear panel, this product also provides two 10-pin USB connectors on its motherboard. By connecting through USB cables with them, user can quickly expand another four USB ports on the front panel . 9 10 F_1394 12 VCC DD+ GND EMPTY VCC DD+ GND NC Speaker Connector : SPEAKER The speaker connector is used to connect speaker of the chassis. 9 10 F_USB 1/2 SPKJ 1 EMPTY 2 NC 3 SPKJ 4 SPEAKER 18