Foxconn Bloodrage GTI English Manual. - Page 26

Fan Connectors : CPU_FAN1, SYS_FAN1, FAN1/2 There are four fan headers on this motherboard. These fans can be automatically turned off after the system enters S3, S4 and S5 sleeping states. SAS_SATA Connectors : SAS_SATA_1/2 The SAS_SATA connectors support both SATA and SAS (Serial Attached SCSI) Hard Disks. Use the bundled SAS cables to connect either a SAS or SATA HDD to these connectors 1 GND +12V SENSE FAN1/2 1 GND POWER SENSE CONTROL CPU_FAN1 SYS_FAN1 2 1 GND TX+ TX- GND RX- RX+ GND SAS_SATA_1/2 Serial ATA Connectors : SATA_1-2, SATA_3-4, SATA_5-6, The Serial ATA connector supports SATA Hard Disks, SSDs and optical Drives. The current Serial ATA II interface allows up to 300MB/s data transfer rates per channel. VFD Connector : VFD The VFD Connector can be connected to the Foxconn QuantumForce OC Panel, which can be installed in any standard 5.25" optical drive bay. It can be used to display the Port80 Debug codes during Bootup, display the system Real Time Clock, display the system temperatures as well as monitor and adjust System voltages and clockspeeds on the fly. With several buttons located on the front panel, you can easily set the Front Side Bus speed, adjust CPU, DRAM and VTT NB voltage and change the fan speeds. It supports profiles which can be loaded within fractions of a second by pushing a single button. You can purchase it to overclock your system on the fly, switch from one oc profile to another during a benchmark, switch from gaming mode to cinema or silent mode. 19 TX- RXGND TX+ GND RX+ GND 1 SATA_1-2/3-4/5-6 RESET 5V 12 ISP GPIO EMPTY GPIO 3.3V NC GND GPIO SDA SCL RXD TXD 13 14 VFD