Frigidaire FGGF3058RF Complete Owner's Guide - Page 26
Operating the oven light, Adjusting the oven temperature, Restoring to factory default settings
View all Frigidaire FGGF3058RF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
SETTING OVEN CONTROLS Adjusting the oven temperature Your appliance has been factory calibrated and tested to ensure an accurate baking temperature. For the first few uses, follow your recipe times and temperature recommendations carefully. If you think the oven is cooking too hot or too cool for your recipe times, you can adjust the control so the oven cooks hotter or cooler than the temperature displayed. The oven temperature may be increased +35°F (+19°C) or decreased -35°F (-19°C) from the factory settings. Example: increase the oven temperature by 30°F: Step Press 1. Press and hold bake for 6 seconds. 2. Enter 30. 3. To accept, press start. Example: decrease the oven temperature by 30°F: Step Press 1. Press and hold bake for 6 seconds. 2. Enter 30. 3. Press self clean. 4. To accept, press start. NOTES • Oven temperature adjustments made will not affect the broil or self-clean operating temperatures. • If the temperature shows an adjustment of -30°F, and a +30°F adjustment is needed, you can toggle between the (-) or (+) in the display by pressing self clean. • Do not use oven thermometers such as those found in grocery stores to check the temperature settings inside your oven. These oven thermometers may vary as much as 20 to 40 degrees from actual temperatures. Restoring to factory default settings When new, your appliance was set with preset oven control settings. Over time, the user may make changes to these default settings. The following features have user program options or adjustments that may have been modified from the factory default settings: • 12 or 24 hour clock display mode. • 6-Hour Engergy Savings or continuous bake mode. • Silent or audible keypad operation. • Oven temperature display mode (F° or C°). • Any oven temperature offset adjustment made. • Temp probe options (some models). • Any stored favorite recipes (some models). IMPORTANT Before restoring the settings, be aware that all changes made to the oven control settings will be erased once the start keypad is pressed. This includes any temperature offset made for the oven. To restore oven control to factory settings: Step Press 1. Press and hold 7 keypad until acceptance tone sounds (about 6 seconds). 2. To accept, press start. Operating the oven light The oven light will automatically turn ON when the oven door is opened. Press to turn the oven light ON and OFF whenever the oven door is closed. The oven light is located at the upper left rear wall of the oven interior and is covered with a glass shield held by a wire holder. The glass shield must be in place whenever the oven is in use. NOTE The oven light will not operate when self-clean is active. If the oven light is ON when setting self-clean, the oven light will turn off. 26