Frigidaire FGGF3058RF Complete Owner's Guide - Page 35

Removing and replacing the lift-off oven door To avoid possible injury when removing or replacing the oven door, follow the instructions below carefully and always handle the oven door with both hands positioned away from the door hinge areas. IMPORTANT The door is heavy. For safe, temporary storage, lay the door flat with the inside of the door facing down. To remove oven door: 1. Open oven door (horizontal with floor - See Fig. 1). 2. Pull the door hinge locks on both left and right door hinges down from the oven frame completely towards the oven door to unlock (See Fig. 2). A tool such as a small flat-blade screwdriver may be required. 3. Close the door to the broil stop position. The oven door will stop into this position just before fully closing. 4. Firmly grasp both sides of oven door along the door sides (Do not use the oven door handle). 5. With the oven door in the broil stop position (Fig. 3), lift the oven door hinge arms over the roller pins located on each side of the oven frame (See Fig. 4). To avoid damage to oven finish, be careful not to allow the oven door hinges to contact the oven front frame. To replace oven door: 1. Firmly grasp both sides of oven door along the door sides (Do not use the oven door handle). 2. Holding the oven door at the same angle as the removal position (See Fig. 3), seat the hook of the hinge arm over the roller pins located on each side of the oven door frame (See Fig. 4). The hook of the hinge arms must be fully seated onto the roller pins. 3. Fully open the oven door (horizontal with floor - See Fig. 1). 4. Push the door hinge locks up towards and into the oven frame for both left and right oven door hinges to the lock position (See Fig. 2). 5. Close the oven door. Special door care instructions - Most oven doors contain glass that can break. Read the following recommendations: • DO NOT close the oven door until all the oven racks are fully positioned inside the oven. • Do not hit door glass with cookware or other objects. • Scratching, hitting, jarring or stressing the glass may weaken its structure causing an increased risk of breakage at a later time. roller pin hinge arm CARE & CLEANING Oven door hinge locations with oven door fully open. Fig. 1 oven door about 10° hinge Fig. 2 Fig. 3 Fig. 4 35