Frigidaire FGGF3058RF Complete Owner's Guide - Page 37

Solutions to common problems • BEFORE YOU CALL Problem Possible Causes Oven portion of appliance does not operate. Gas cooktop burners operate. Gas regulator shut-off valve may have been moved to OFF at installation. Incorrect oven control setting. Entire appliance does Power supply to appliance not operate. disconnected or electrical power outage. Service wiring is incomplete. Range is not level. Floor is not level, weak or unstable. The cooktop or oven racks are not level. Cabinet alignment may make range appear not level. Cannot move appliance easily. Appliance must be accessible for service. Gas line is hard-plumbed. Carpet interferes with range. Cabinets are built in too tightly to appliance sides. Convect fan makes The convect fan may turn ON noise (some models). or OFF automatically. Convect fan does not start immediately or turns ON and OFF while cooking (some models). The convect fan start time is delayed. Oven door is open. Convect fan turns on with features that should run without a fan (some models). The convect fan may turn ON while preheating. Oven control displays "Prob ERR". The probe is not recognized by the oven control. The probe is not fully inserted into the probe receptacle. If the error code persists, the probe may be damaged or the probe cable has a short. Solutions Be sure gas regulator valve is set to the ON position. See installation instructions. Be sure the oven control was set correctly for the requested feature. See Setting Oven Controls section and review instructions for the desired cooking function in this manual or see "Entire appliance does not operate" in this checklist. Be sure appliance power cord is plugged properly to electrical outlet. Check house circuit breaker; reset if needed. If the electric service to the house is out, call your local electric utility for service. Contact your dealer, installing agent or authorized service agent for assistance. If floor under range is sagging or sloping, contact a carpenter to correct the problem. To correct, place oven rack in center of oven. Place a bubble level centered on the oven rack. Adjust by turning leveling legs at bottom of range until the oven rack rests level. Be sure kitchen cabinets are square and have sufficient room for appliance clearance. Replace gas supply line with a flexible CSA International approved metal appliance connector. Provide sufficient space so appliance may be lifted over carpet. Contact builder or installer to make appliance accessible. This is normal. On some cooking features the convect fan may run until the feature is done or the oven door is opened. This is normal. The convect fan will take 6 minutes to begin rotating after starting any convect feature. The convect fan will turn OFF if the oven door is opened while any convect feature is active. Close oven door. This is normal (on some models). Double check that the temp probe is fully inserted into probe receptacle. Use only the probe originally supplied with range. Remove the probe from receptacle and oven. The oven may still be used normally without the probe. Call your authorized service agent. 37