Genie ScrewDrive Owner's Manual - Page 14

MAIN ASSEMBLY OPEN GREEN PARTS BAG Screws for attaching light cover are included in this bag. Please set aside for use later. 14 14. Attach emergency release knob, cord and tag. • Tie an overhand knot in one end of emergency release cord [17]. - Slide cord through center of knob [18]. Fig. 1-17. - Slide cord through hole in emergency release lever (on carriage). - Tie a second knot in this end. Fig. 1-18. - Slip wire of emergency release tag [19] through hole in emergency release lever and twist it around itself. 15. Attach limit switches. • "CLOSE" limit switch [15B]. (Switches are identical.) - Place "CLOSE" limit switch over top of rail about 12 inches from rail strap. Fig. 1-19. - Check that white lever is toward power head. - Insert set screw [16] into limit switch hand tight only to temporarily hold switch in place. Fig. 1-19A. - Attach brown wire to switch. Fig. 1-19B. - Leaving some slack in wire (Fig. 1-20), run wire down inside groove in top of rail back to power head. - Use wire clip [44] to help maintain slack. Fig. 1-20. • "OPEN" limit switch [15A]. - Place "OPEN" limit switch over top of rail about 12 inches from power head. Fig. 1-21. - Check that white lever is on side away from power head. (This means limit switches hang off opposite sides of rail. Check this to help verify they are installed properly.) - Insert set screw [16] into limit switch hand tight only to temporarily hold switch in place. - Attach grey wire to switch. Fig. 1-21. - Leaving some slack in wire (Fig. 1-21), run wire down inside groove in top of rail back to power head. - Use wire clip [44] to help maintain slack. Fig. 1-21. • Coil excess wire and tape it to top of power head. Fig. 1-21A. [16] #8-32 x 3/8" Hex head screw [44] Wire clip FOR HELP-1.800.354.3643 OR GENIECOMPANY.COM release knob Fig. 1-17 cord tag Fig. 1-18 B Fig. 1-19 "close" switch set screw A brown wire wire clip Fig. 1-20 "open" switch grey wire Fig. 1-21 power head A