Genie ScrewDrive Owner's Manual - Page 19

Mounting power head., Fig. 2-9, Fig. 2-10, Fig. 2-11, DO NOT, ATTACH TO DRY WALL OR, SUSPENDED - door opener

Get Genie ScrewDrive PDF manuals and user guides View all Genie ScrewDrive manuals
Add to My Manuals
Save this manual to your list of manuals

Page 19 highlights

INSTALLATION FOR HELP-1.800.354.3643 OR GENIECOMPANY.COM 8. Mounting power head. • Raise power head and support it high enough that you can manually raise garage 19 door fully open. • Line up power head and rail with center of door. Fig. 2-9. • Keeping power head centered, mount to ceiling: - at proper height; a. for sectional doors rail should be level with floor or slightly below level. Fig. 2-10. b. for 1-piece doors rail should clear door by about 2 inches. Fig. 2-10. Fig. 2-9 SECTIONAL LEVEL OR SLIGHTLY BELOW LEVEL 1-PIECE MUST CLEAR DOOR BY 2 INCHES AT HIGHEST POINT OF TRAVEL 2" Fig. 2-10 - using one of the preferred methods shown, Fig. 2-11, mount power head. (It is possible to use other mounting methods. The critical point to remember is that the mounting assembly must be solidly attached and able to support the weight of the power head.) DO NOT ATTACH TO DRY WALL OR SUSPENDED CEILING. It must be anchored to the framework of the garage. • Fully tighten rail strap nut. Mounting Straps Wood Fig. 2-11 [22] [48] Perforated Angle Iron [46] [9] FINISHED CEILING

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
19
INSTALLATION
FOR HELP-1.800.354.3643 OR GENIECOMPANY.COM
8.
Mounting power head.
•
Raise power head and support it high
enough that you can manually raise garage
door fully open.
•
Line up power head and rail with center of
door.
Fig. 2-9
.
•
Keeping power head centered, mount
to ceiling:
–
at proper height;
a.
for sectional doors rail should be level
with floor or slightly below level.
Fig. 2-10
.
b.
for 1-piece doors rail should clear
door by about 2 inches.
Fig. 2-10
.
–
using one of the preferred methods
shown,
Fig. 2-11
, mount power head.
(It is possible to use other mounting
methods. The critical point to remember is
that the mounting assembly must be
solidly attached and able to support the
weight of the power head.)
DO NOT
ATTACH TO DRY WALL OR
SUSPENDED CEILING
. It must be
anchored to the framework of the garage.
•
Fully tighten rail strap nut.
Fig. 2-9
SECTIONAL LEVEL OR SLIGHTLY BELOW LEVEL
1-PIECE MUST CLEAR DOOR BY 2 INCHES AT HIGHEST POINT OF TRAVEL
2"
Fig. 2-10
Perforated
Angle Iron
Mounting
Straps
FINISHED CEILING
Wood
Fig. 2-11
[22]
[48]
[46]
[9]