HP 381513-B21 HP Smart Array P800 Controller for Integrity Servers Installatio - Page 29

IMPORTANT: Both saupdate.efi and the firmware image file must be located in the same directory. If they are not, copy them both to the EFI partition. Run the saupdate.efi using the fs0:\> saupdate command. • If you are not using the Offline Diagnostic CD: 1. Download the SA EFI update utility saupdate.efi and copy it to the EFI partition. 2. Download the firmware and copy it to the EFI partition. 3. Boot the system to the EFI Shell and change directories to the EFI partition. • When you are ready to run saupdate, use saupdate UPDATE to update the firmware on the controller. The syntax of the saupdate UPDATE command is as follows: saupdate UPDATE For example, to update the controller at segment 0, bus 52, device 0, function 0 from the example output above: fs0:\> saupdate UPDATE 0:52:0:0 INCPTR.PAK Replace INCPTR.PAK with the name of your firmware file. For example: fs0:\EFI\TOOLS> saupdate update 0:52:0:0 INCPTR.PAK Smart Array Offline Firmware Update Utility Version 2.06.10.03 (C) Copyright 2006 Hewlett-Packard Development Company, L.P Updating controller in Seg: 0, Bus: 52, Dev: 0, Func: 0 Current firmware version 2.06 Percentage completed: 100% Activating firmware now, this may take several minutes. Resetting and reinitializing controller. Retrieving firmware version, this may take several minutes. Current controller firmware version is 2.08. Verifying the Firmware Update After updating the firmware, cycle the power on the system and on any external JBODS connected to the system. After performing the firmware update, use LIST to confirm that the correct firmware version is installed; see "Verifying the Controller Firmware" (page 11). For example: fs0:\EFI\TOOLS> saupdate list Smart Array Offline Firmware Update Utility Version 2.06.10.03 (C) Copyright 2006 Hewlett-Packard Development Company, L.P Seg Bus Dev Func Description Version 0 52 0 0 HP Smart Array P400 2.08 Verifying and Updating Controller Firmware Offline 29