HP 3PAR StoreServ 7400 2-node HP 3PAR Management Console 4.3.0 Software User&a - Page 46
Detail Pane, iSCSI Port Summary, iSCSI Port Summary Sessions Tab
View all HP 3PAR StoreServ 7400 2-node manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Column MTU Partner Partner WWN Failover State Description Maximum Transmission Unit. The greatest amount of data or "packet" size that can be transferred at one time over a particular network connection without overburdening the connection. The default MTU setting for an iSCSI port is 1500. When supported by the network, an MTU value of 9000 should be used. The partner port. The WWN of the partner port. Indicates if the system is in a failover state. Detail Pane The detail pane provides detailed information about a selected port from the list pane. Information is presented a Summary tab, a Sessions tab, and a Hosts tab. Each are discussed in detail in the following sections: "iSCSI Port Summary" (page 46) "Sessions Tab" (page 47) "Hosts Tab" (page 47) iSCSI Port Summary The iSCSI port summary is displayed on the Summary tab. The following information is provided: Group General Resources IP Settings Field Description Position The port location in Node:Slot:Port format. Label The designated port label. Type Indicates whether the port is FC, iSCSI, RCIP, or RCFC. Rate Rate that data can be transferred over the port (1 Gbps, 2 Gbps or 4 Gbps). When there is no specified value, no connection exists. Connected Device Type Type of device that the port is connected to. Free, Disk, Host, Peer, or InServ. Connected Device Name of device that the port is connected to, e.g. host1, cage0. Mode Port firmware mode setting. Ports in Initiator mode are connected to drive cages and ports in Target mode export to hosts. Suspended mode is for target ports that have not yet been initialized by the system (rare). Peer mode is for Ethernet ports. State Current state of the port. MAC The Media Access Control address for the Ethernet interface. TPGT The Target Portal Group Tag for the iSCSI target portal group. Total Data Throughput The throughput in KB/sec. DHCP For iSCSI ports. Indicates if the Dynamic Host Configuration Protocol (DHCP) protocol is enabled or disabled. IP Address IP address of the iSCSI port. Gateway The address of a local IP router on the same network as the Storage System, used to forward traffic to destinations beyond the local network. Subnet Mask Netmask address for the iSCSI interface. 46 Managing Ports