HP 3PAR StoreServ 7400 4-node HP 3PAR Command Line Interface Reference (OS 3.1 - Page 248

removespare DESCRIPTION The removespare command removes chunklets from the spare chunklet list. SYNTAX removespare [options] ... AUTHORITY • Super, Service • Any role granted the spare_remove right. NOTE: You need access to all domains in order to run this command. OPTIONS -f Specifies that the operation is forced. If this option is not used, the command requires confirmation before proceeding with its operation. -p Specifies that partial completion of the command is acceptable. Chunklets specified that are not on the current service group spare list are ignored. SPECIFIERS ... The chunklet specifier can be issued in the following formats: ... Specifies the identification of the physical disk (PD_ID) and the position number of the chunklet on the disk (chunklet_num). This specifier can be repeated. :a... Specifies the identification of the physical disk (PD_ID) and all (a) chunklets on the disk. This specifier can be repeated. a:... Specifies the chunklet number on all physical disks. This specifier can be repeated. a:a Removes all spare chunklets that are not currently used. -pos Specifies the position of a specific chunklet identified by its position in a drive cage, drive magazine, physical disk, and chunklet number. For example -pos 1:0.2:3:121, where 1 is the drive cage, 0.2 is the drive magazine, 3 is the physical disk, and 121 is the chunklet number. -pos Specifies that all chunklets on a physical disk, identified by drive cage number, drive magazine number, and disk number, are marked to be removed. RESTRICTIONS Access to all domains is required to run this command. 248 Remove Commands