HP 3PAR StoreServ 7400 4-node HP 3PAR Command Line Interface Reference (OS 3.1 - Page 335

PortFailoverEnabled Enables or disables the automatic failover of target ports to their designated partner ports. If enabled, automatic failover is triggered when a node goes down. can be 'yes' or 'no'. The default is 'yes'. AutoExportAfterReboot Enables or disables automatically exporting vluns after a reboot. If disabled, vluns and host ports will not become active after a reboot until 'setsysmgr export_vluns' is issued. can be 'yes' or 'no'. The default is 'yes'. AllowR5onNLDrives Enables or disables support for RAID-5 on NL drives. If disabled, new RAID-5 CPGs cannot be created on NL drives. HP strongly recommends RAID-6 for high-capacity NL drives. can be 'yes' or 'no'. The default is 'no'. AllowR0 Enables or disables support for RAID-0. If disabled, new RAID-0 CPGs cannot be created on this system. RAID-0 virtual volumes do not offer data protection. can be 'yes' or 'no'. The default is 'no'. RESTRICTIONS Access to all domains is required to run this command. EXAMPLES The following example displays setting a raw space alert of 800 gigabytes: cli% setsys RawSpaceAlertFC 800 cli% showsys -param System parameters from configured settings ----Parameter----- RawSpaceAlertFC : RawSpaceAlertNL : RemoteSyslog : RemoteSyslogHost : SparingAlgorithm : CopySpaceReclaim : EventLogSize : VVRetentionTimeMax : ---Value---800 0 1 192.168.6.15 Minimal 0 3M 336 Hours NOTES Use the showsys -param command to see the current raw space alert setting (see Section (page 482)). setsys 335