HP 3PAR StoreServ 7400 4-node HP 3PAR Command Line Interface Reference (OS 3.1 - Page 278
setbattery, Specifies the power supply number on the node using either
View all HP 3PAR StoreServ 7400 4-node manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 278 highlights
setbattery DESCRIPTION The setbattery command sets battery information such as the battery's expiration date, its recharging time, and its serial number. This information gives the system administrator a record or log of the battery age and battery charge status. SYNTAX setbattery [options ] setbattery [options ] AUTHORITY • Super, Service • Any role granted the battery_set right. NOTE: You need access to all domains in order to run this command. OPTIONS -s Specifies the serial number of the battery using a limit of eight alphanumeric characters. -x Specifies the expiration date of the battery (mm/dd/yyyy). The expiration date cannot extend beyond 2037. -l Specifies that the battery test log is reset and all previous test log entries are cleared. -r Specifies that the battery recharge time is reset and that 10 hours of charging time are required for the battery to be fully charged. SPECIFIERS Specifies the node number where the battery is installed. Specifies the power supply number on the node using either 0 (left side from the rear of the node) or 1 (right side from the rear of the node). Specifies the battery number on the power supply where 0 is the first battery. NOTE: The and specifiers can be obtained from the output of the showbattery command. RESTRICTIONS Access to all domains is required to run this command. 278 Set Commands