HP 3PAR StoreServ 7400 4-node HP 3PAR Command Line Interface Reference (OS 3.1 - Page 530

24 Shutdown Commands shutdownnode DESCRIPTION The shutdownnode command shuts down a system node. SYNTAX shutdownnode halt|reboot|wipeid AUTHORITY • Super, Service • Any role granted the node_shutdown right. NOTE: You need access to all domains in order to run this command. SUBCOMMANDS halt Specifies that the nodes are halted after shutdown. If this subcommand is not specified, the reboot or wipeid (StoreServ 7000 only) subcommand must be used. reboot Specifies that the nodes are restarted after shutdown. If this subcommand is not specified, the halt or wipeid (StoreServ 7000 only) subcommand must be used. wipeid StoreServ 7000 only subcommand. this will wipe the EEPROM and leave the node in the halt state, if this command is not specified then the reboot or halt subcommand must be used. OPTIONS None. SPECIFIERS Specifies the node, identified by its ID, to be shut down. EXAMPLES The following example shuts down system node 0 and halts the restarting of the node: cli% shutdownnode reboot 0 -----System Information----System Name : ma1tp001 System Model : InServ S800X Serial Number : 1000787 Partial List Of Hosts Id Name Persona -WWN/iSCSI_Name- Port IP_addr 0 sunx4150-01 Generic-legacy 2101001B32343495 0:5:1 n/a 1 sunx4150-02 Generic-legacy 2101001B32344695 0:5:1 n/a 2 sunx4150-03 Generic-legacy 2100001B32147595 0:5:1 n/a 530 Shutdown Commands