HP 418800-B21 HP StorageWorks 70 Modular Smart Array Enclosure maintenance and - Page 35

Removing the front UID module, Installing the front UID module, Verifying component replacement

Get HP 418800-B21 - StorageWorks Modular Smart Array 70 Storage Enclosure PDF manuals and user guides
UPC - 882780564640
View all HP 418800-B21 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 35 highlights

Blue = Identified Blue flashing = Active remote management Off = No active remote management • Check the host log for errors. Removing the front UID module 1. Power down the enclosure: a. Power down any attached servers. See the server documentation. b. Press the Power On/Standby button on the enclosure. c. Wait for the system power LED to go from green to amber. d. Disconnect the power cords. 2. Remove the plastic bezel (1). 3. Remove the T-10 screw to release the module from the chassis (2). 4. Remove the front UID module (3). Installing the front UID module To install the front UID module, reverse the removal procedure: 1. Attach the module to the chassis, securing it with a T-10 screw. 2. Install the plastic bezel. 3. Power up the enclosure. Verifying component replacement After replacing the front UID module, check the front UID module status LED. Removal and replacement procedures 35

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
Removal and replacement procedures
35
Blue
= Identified
Blue flashing
= Active remote management
Off
= No active remote management
•
Check the host log for errors.
Removing the front UID module
1.
Power down the enclosure:
a.
Power down any attached servers. See the server documentation.
b.
Press the Power On/Standby button on the enclosure.
c.
Wait for the system power LED to go from green to amber.
d.
Disconnect the power cords.
2.
Remove the plastic bezel (1).
3.
Remove the T-10 screw to release the module from the chassis (2).
4.
Remove the front UID module (3).
Installing the front UID module
To install the front UID module, reverse the removal procedure:
1.
Attach the module to the chassis, securing it with a T-10 screw.
2.
Install the plastic bezel.
3.
Power up the enclosure.
Verifying component replacement
After replacing the front UID module, check the front UID module status LED.