HP 418800-B21 HP StorageWorks 70 Modular Smart Array Enclosure maintenance and - Page 38

Installing the power on/off module, Verifying component replacement

Get HP 418800-B21 - StorageWorks Modular Smart Array 70 Storage Enclosure PDF manuals and user guides
UPC - 882780564640
View all HP 418800-B21 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 38 highlights

6. Disconnect the cable from the power on/off module (1). 7. Loosen the thumbscrew on the module (2). 8. Slide the module back to remove it from the guide, and then lift it out of the chassis (3). Installing the power on/off module To install the power on/off module, reverse the removal procedure: 1. Slide the module into the chassis using the guide and tighten the thumbscrew. 2. Connect the cable to the module. 3. Install the power supply and the front UID module. 4. Insert the enclosure into the rack and power up the enclosure. Verifying component replacement After replacing the power on/off module, check the heartbeat, fault, and power supply status LEDs to verify the module is operating normally. Removal and replacement procedures 38

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
Removal and replacement procedures
38
6.
Disconnect the cable from the power on/off module (1).
7.
Loosen the thumbscrew on the module (2).
8.
Slide the module back to remove it from the guide, and then lift it out of the chassis (3).
Installing the power on/off module
To install the power on/off module, reverse the removal procedure:
1.
Slide the module into the chassis using the guide and tighten the thumbscrew.
2.
Connect the cable to the module.
3.
Install the power supply and the front UID module.
4.
Insert the enclosure into the rack and power up the enclosure.
Verifying component replacement
After replacing the power on/off module, check the heartbeat, fault, and power supply status LEDs to
verify the module is operating normally.