HP A3550A User Manual - A3661-90001 - Page 287

Troubleshooting Table 6-8 Informational Codes Event code Event code name Description 0x601 SP Power Up 0x602 Drive Enabled The SP is powered up and ready for I/O. This field also shows the revision of microcode (Licensed Internal Code) and the amount of SP memory in MB, in hexadecimal. For example, (SP Powerup); Rev 0x00080A01 0x00000020 means code revision 8.10.01 and 32 MB of memory. The unit this drive belongs to is ready for normal host I/O. 0x603 Rebuild Started The background rebuild process has begun rebuilding the data on this drive. 0x604 0x606 Rebuild Completed Unit Shutdown for Trespass The background rebuild process has completed rebuilding the data on this drive. The unit of which this drive is a member has been shut down by this SP at the request of the peer SP, due to a Trespass operation. 0x607 0x608 0x609 0x610 0x611 0x613 Unit Shutdown for Change Bind Drive Ready Format Started Format Failed SP PROM Rev CRU Equalize Started The LUN this module belongs to has been shut down by this SP in order to change its operating parameters. This shutdown is needed only when the SP is operating in Target Addressing Mode. The specified drive is powered up and physically ready for use. The given FRU is being formatted. The format started on the disk module was unsuccessful so the disk can not be used by the SP. Make sure the disk module is a valid model. If it is valid, consult your HewlettPackard support representative for recovery service. Notes PROM revision, the extended status identifies the SP's ID. This message is logged once at the completion of every powerup. The SP has started a Rebuild/Equalize operation. 0x614 0x615 0x616 0x617 CRU Equalize Completed The SP has completed a Rebuild/Equalize operation. CRU Equalize Aborted The SP has aborted a Rebuild/Equalize operation. Flare Installed Extended status identifies revision information. This message is logged once when new flare code is installed. Code Installed to Drive Extended status identifies revision information. This message is logged, once for each updated drive, when new drive code is installed. Note that the revision information for drives consists of 4 ASCII characters (for example, code "0123" will appear as 0x30313233). Unsolicited Event Log 6-39