HP A3550A User Manual - A3661-90001 - Page 298

Table 6-12 Extended Status Codes Extended Extended status code status code name Description 0x00 0x01 None SCSI protocol error No error information available. An error was detected and retried during activity on an internal SCSI bus between the SP and the disk itself. 0x02 0x03 Device detected parity error Drive returned sense data indicating data sourced at the SCSI interface device on the SP encountered an internal parity error. Device busy Drive returned a "SCSI Busy" status indicating more than one request was sent to the disk before the first one completed. This can be seen most frequently in dual initiator (host) configurations. 0x04 0x05 0x06 0x07 0x08 0x09 0x0A 0x0B 0x0C Improper SCSI status byte Media error Time-out error Selection time-out Not ready Hardware error Bad format Wrong device User abort An unrecognized status byte was received during a SCSI transfer, possibly due to a SCSI protocol violation. A hard media error was detected at the disk level and the sector remapped. The SP microcode allocates 10 seconds for a disk to complete a command. This error is a result of a disk not completing a command within the allocated response time. The targeted drive did not respond to SCSI selection. A status of 0x47 indicates retries failed. The drive returned a "Not Ready" SCSI Sense Key. The drive returned "Hardware Error" Sense Key. Indicates an internal electro-mechanical problem on the disk module. Indicates the drive format has changed from the expected sector standard for the array. The drive is reporting a type not supported. This error code should never be seen. 0x0D 0x0E Illegal request Device saw bus reset The drive returned an "Illegal Request" Sense Key. This indicates an illegal command was sent to the disk. The drive reported a Unit Attention resulting from the SP microcode issuing a SCSI Bus Reset. The drive was idle at time of reset or was just inserted. 0x0F Mode select occurred This error code should never be seen. 6-50 Unsolicited Event Log