HP A3550A User Manual - A3661-90001 - Page 301

Troubleshooting Table 6-12 Extended Status Codes (Continued) Extended Extended status code status code name Description 0x3E 0x3F 0x7E 0x80 0x81 Media error remap failed Media error bad defect list Extended media error CRU Powered Down CRU Powered Up Dead An attempt to do a remap after a Media error failed for some reason other than one of the following: another media error, a timeout, cannot remap (no LBA provided), or bad defect list. All of these errors are itemized separately. Device returned a Media Error check condition which specifically indicates that the device's "defect list" is no good (03/19) or (03/1c). A remap is not possible for these errors. A remap of a bad block failed. Usually seen with event codes 0x820 or 0x920. During a sniff, the device was found to be powered down. While powering up a CRU died. 0x82 0x83 CRU Defined Powered Down CRU Defined Dead Switched from defined state to powered down Drive found dead while in defined state. 0x84 0x85 0x86 CRU Too Small CRU Unsupported CRU Format Failed Drive is too small to fit in the assigned LUN. Drive is not supported and has been shutdown. The format of the drive aborted for some reason. Further information may be provided in other Unsolicited Event Log messages. 0x87 0x88 0x89 CRU Idle Powered Down CRU Idle Dead CRU Bind Powered Down CRU was found to have powered down while idle. CRU died while in idle state. The drive powered down while unbound. 0x8A 0x8B CRU Bind Dead CRU Wait for Assign Powered Down CRU died while unbound. CRU powered down while in the RDY state. 0x8C Shutdown Shutdown while waiting to assign a LUN. Usually seen with event code 0xA07. CRU died in RDY state. 0x8D 0x8E CRU Rebuild Powered Down CRU Rebuild Dead CRU powered down during a rebuild. CRU died during a rebuild. 0x8F 0x90 CRU Enabled Powered Down CRU Enabled Dead CRU powered down in ENA state. CRU died in ENA state. Unsolicited Event Log 6-53