HP AE326A HP StorageWorks 1500 Modular Smart Array maintenance and service gui - Page 90
Verifying component failure, Removing the component, Before replacing the SCSI I/O module
UPC - 882780184954
View all HP AE326A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 90 highlights
Verifying component failure Before replacing the SCSI I/O module: • Verify that the module Status LED is off or is blinking amber. • Check the array controller LCD display panel for error messages. Removing the component CAUTION: The SCSI I/O module is not hot-pluggable. Before replacing the module, all I/O from the servers must be stopped and the MSA must be powered down. 1. Review all warnings, cautions, and preparation procedures as detailed in Warnings and precautions. NOTE: Before removing the SCSI I/O module, label all cables. This ensures their reconnection in the correct configuration. 2. Disconnect all SCSI cables from the SCSI I/O module. 3. Lift the port-colored SCSI I/O module latch (1) and pull the SCSI I/O module out of the chassis (2). 2 1 15496 Installing the component 1. Slide the replacement SCSI I/O module into the MSA chassis bay until the module clicks into place. 90 Customer replaceable components