HP AP775A Cisco NX-OS System Messages Reference (OL-15994-03, July 2009) - Page 158
DIAGCLIENT-2, A Health Monitoring Test has reported failure.
UPC - 884962062708
View all HP AP775A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 158 highlights
DIAGCLIENT Messages Chapter 2 System Messages and Recovery Procedures Send document comments to [email protected] DIAGCLIENT-2 Error Message DIAGCLIENT-2-DIAG_BOOTUP_COMPLETE: Module Bootup Test has reported Explanation Bootup Test completed. Recommended Action Nothing to be done if the test reports SUCCESS otherwise copy the error message exactly as it appears on the console, gather the output of show tech-support, and contact your Cisco technical support representative with the gathered information. Error Message DIAGCLIENT-2-EEM_ACTION_HM_SHUTDOWN: Test has been disabled as a part of default EEM action Explanation Informational Syslog. Recommended Action No action is required. Error Message DIAGCLIENT-2-PSS_READ_FAILURE: Read from PSS failed on Module Explanation Read operation from PSS store failed. Recommended Action No action is required. Error Message DIAGCLIENT-2-PSS_WRITE_FAILURE: Write to PSS failed on Module Explanation Write operation on PSS store failed. Recommended Action No action is required. DIAGCLIENT-3 Error Message DIAGCLIENT-3-DIAG_HM_FAIL: Module Health Monitoring Test has failed. Please use 'show diagnostic result ' to see test results Explanation A Health Monitoring Test has reported failure. Recommended Action Ensure the line card is firmly in the slot, reseat if necessary, and attempt to run the test again if the line card is not seated properly in the slot. If the line card was properly seated in the slot, copy the error message exactly as it appears on the console, gather the output of show tech-support, and contact your Cisco technical support representative with the gathered information. 2-120 Cisco NX-OS System Messages Reference OL-15994-03