HP AP775A Cisco NX-OS System Messages Reference (OL-15994-03, July 2009) - Page 661
This can happen as a result of a topology change in the network while the Linecard was
UPC - 884962062708
View all HP AP775A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 661 highlights
Chapter 2 System Messages and Recovery Procedures STP Messages Send document comments to [email protected] Error Message STP-2-SET_PORT_STATE_FAIL: Port state change req to PIXM failed, status = [hex] [[chars]] vdc [dec], tree id [dec], num ports [dec], ports [chars] state [chars], opcode [chars], msg id ([dec]), rr_token [hex] Explanation The port set port state hasfailed. Checkthe port. Recommended Action No user action is required. Error Message STP-2-SET_PORT_STATE_TIMEOUT: Port state change req to PIXM timedout after [dec] sec. vdc [dec], tree id [dec], num ports [dec], ports [chars] state [chars], opcode [chars], msg id ([dec]), rr_token [hex] Explanation The port set port state has timed outCheck the port. Recommended Action No user action is required. Error Message STP-2-STP_INIT: STP initialization of [chars] [chars] Explanation STP initialization has failed. Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco Support web site http://www.cisco.com/tac. Error Message STP-2-STP_ISSU_LC_RESET: STP resetting LC[dec] to prevent Loops during ISSU caused by a topology change in the network. Peer on [chars] [chars] could not be Disputed Explanation This can happen as a result of a topology change in the network while the Linecard was undergoing ISSU. Since STP cannot change the port state to blocking on the Linecard undergoing ISSU, it will first try to prevent the Loop by causing a Dispute on the peer ports forcing them into blocking state. But if the peer does not support Dispute mechanism, and STP detects a potential Loop, it will reset the Linecard to prevent the Loop. Recommended Action No user action is required. Error Message STP-2-UNBLOCK_CONSIST_PORT: Unblocking port [chars] on [chars]. Port consistency restored. Explanation The Port VLAN ID and/or Port Type inconsistencies have been resolved and spanning tree will now unblock the listed interface of the listed spanning tree instance as appropriate. Recommended Action No user action is required. Error Message STP-2-UNBLOCK_DETECTED_PVST_PEER: Unblocking port [chars] [PVST peer detected]. Explanation The listed interface has stopped receiving SSTP BPDUs and so will be restored to normal spanning tree state. Recommended Action No user action is required. OL-15994-03 Cisco NX-OS System Messages Reference 2-623