HP AP775A Cisco NX-OS System Messages Reference (OL-15994-03, July 2009) - Page 663
STP-3, Cisco NX-OS System Messages Reference, OL-15994-03,
UPC - 884962062708
View all HP AP775A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 663 highlights
Chapter 2 System Messages and Recovery Procedures STP Messages Send document comments to [email protected] STP-3 Error Message STP-3-BLOCK_PORT_TYPE: Blocking [chars] on [chars]. Inconsistent port type. Explanation The listed interface is being held in spanning tree blocking state until the port type inconsistency is resolved. Recommended Action Verify that the configuration and operational state of the listed interface and that of the interface to which it is connected have the same mode (access vs trunk). If mode is trunk, verify the same encapsulation (ISL, 802.1Q). Once these parameters are consistent, spanning tree will automatically unblock the interfaces as appropriate. Error Message STP-3-PORT_SELF_LOOPED: Received BPDU src mac same as that of port. Port self loopback detected. Port [chars] being disabled Explanation The source MAC address contained in a BPDU received on the listed interface matches the MAC address assigned to that interface This indicates the possibility that a port is looped back to itself, possibly due to a diagnostic cable being plugged in. The interface will be administratively shutdown. Recommended Action Check the interface configuration and any cable plugged into the interface. Once the problem is resolved, re-enable interface by doing a no shutdown in the interface configuration. Copy the error message as it is printed and also copy the output of a show interface for the interface listed in the error message. Error Message STP-3-RECV_1Q_NON_TRUNK: Received 802.1Q BPDU on non trunk [chars] [chars]. Explanation A SSTP BPDU was received on the listed interface that was not operationally a trunk. Recommended Action Verify that the configuration and operational state of the listed interface and that of the interface to which it is connected have the same mode (access vs trunk). If mode is trunk, verify the same encapsulation (none, ISL, 802.1Q). Once these parameters are consistent, spanning tree will automatically unblock the interfaces as appropriate. OL-15994-03 Cisco NX-OS System Messages Reference 2-625