HP AP775A Cisco NX-OS System Messages Reference (OL-15994-03, July 2009) - Page 163
DIAGMGR-6, DMM-SLOT# Messages
UPC - 884962062708
View all HP AP775A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 163 highlights
Chapter 2 System Messages and Recovery Procedures DMM-SLOT# Messages Send document comments to [email protected] Error Message DIAGMGR-5-INTRVL_INCORRECT: Monitoring Interval is less than minimum of [dec] seconds required for Module test Explanation Health Monitoring cannot be enabled for the specified test because the interval for the test has been incorrectly set. Recommended Action The system is working properly and no action is required. If you want to specify a smaller testing interval, the error message text provides the lowest possible configurable interval for the specified monitoring interval. Error Message DIAGMGR-5-MODULE_MISSING: Diagnostic command issued on non-existing Module Explanation A line card could not be located in a slot where a diagnostic action was requested. Recommended Action Ensure the targeted line card is properly seated in the specified slot. If the line card is properly seated, ensure the correct slot was indicated in the command-line interface. If the line card is well-seated and the correct slot was specified, copy the error message exactly as it appears on the screen as well as the output of show tech-support and paste the output into a separate file. Contact your technical support representative with the gathered information. Error Message DIAGMGR-5-NONHM_AS_HM: The Test cannot be used as health monitoring test Explanation Non-HM test cannot be scheduled to run as a Health Monitoring test. Recommended Action No action is required. DIAGMGR-6 Error Message DIAGMGR-6-BOOTUP_DIAG_OK: Module : Passed Online Diagnostics Explanation The diagnostic tests did not detect any error on the card. Recommended Action This is an informational message stating that the line card passed the diagnostic tests. Error Message DIAGMGR-6-BOOTUP_TEST_STARTED: Module : Running [chars] Diagnostics Explanation Starting bootup testing for above module. Recommended Action No action is required. DMM-SLOT# Messages This section contains the DMM-SLOT# messages. OL-15994-03 Cisco NX-OS System Messages Reference 2-125