HP AP775A Cisco NX-OS System Messages Reference (OL-15994-03, July 2009) - Page 803
client. The client probably restarted ungracefully and URIB has the old id.
UPC - 884962062708
View all HP AP775A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 803 highlights
Chapter 2 System Messages and Recovery Procedures URIB Messages Send document comments to [email protected] Error Message URIB-3-DEL_ERROR Format: Could not delete %s/%d from %s Explanation A error was encountered. The system may run into more errors because of this problem. Recommended Action Use the 'system switchover' command to switch over to the standby supervisor. If no standby is present, or the standby is not ready, use the 'reload' command to reload the system. The state of the standby can be checked using the 'show system redundancy ha status' command. Error Message URIB-3-EPID_MIS_MATCH_ERROR Format: \%s\ epid (%u) does not match known epid (%u) Explanation The id a client provided does not match the id that URIB currently has stored for the client. The client probably restarted ungracefully and URIB has the old id. Parameters: Client, Expected epid, Received epid ... Recommended Action Use the 'restart' command to restart the feature and clear this problem. Error Message URIB-3-FILE_OPEN_ERROR Format: File open error: %s Explanation This message is for internal debugging only. Recommended Action No action is required. Error Message URIB-3-FILE_WRITE_ERROR Format: File write error: %s Explanation This message is for internal debugging only. Recommended Action No action is required. Error Message URIB-3-GENERAL_CRIB_ERROR Format: %s Explanation CRIB not in use. Recommended Action No action is required. Error Message URIB-3-GENERAL_PTHREAD_ERROR Format: Thread %d: %s Explanation The POSIX pthread library returned an error to URIB. Parameters: Thread name, Thread operation ... Recommended Action Use the 'system switchover' command to switch over to the standby supervisor. If no standby is present, or the standby is not ready, use the 'reload' command to reload the system. The state of the standby can be checked using the 'show system redundancy ha status' command. OL-15994-03 Cisco NX-OS System Messages Reference 2-765