HP AP775A Cisco NX-OS System Messages Reference (OL-15994-03, July 2009) - Page 528
Platform-3
UPC - 884962062708
View all HP AP775A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 528 highlights
PLATFORM Messages Chapter 2 System Messages and Recovery Procedures Send document comments to [email protected] Error Message PLATFORM-2-SYS_IDPROMBAD_RECOVER_PASS: Chassis IDPROM [dec] data re-initialized successfully Explanation Chassis IDPROM [decimal digit] invalid data was succesfully re-initialized to valid. Recommended Action Enter a 'show sprom module [decimal digit] 1' to read module IDPROM contents and verify the information. Error Message PLATFORM-2-XBAR_DETECT: Xbar [dec] detected (Serial number [chars]) Explanation A new xbar in slot [decimal digit] is detected. Recommended Action No action is required. Error Message PLATFORM-2-XBAR_PWRFAIL_EJECTORS_OPEN: Both ejectors open, Xbar [dec] will not be powered up (Serial number [chars]) Explanation The xbar cannot be powered up because both ejectors are open. Recommended Action Enter a 'show platform internal all module [decimal digit]' and 'show module internal all module [decimal digit]' 'show sprom xbar [dec] [dec]' to read module IDPROM contents to collect more information. Error Message PLATFORM-2-XBAR_REMOVE: Xbar [dec] removed (Serial number [chars]) Explanation The xbar in slot [decimal digit] has been removed. Recommended Action No action is required. PLATFORM-3 Error Message PLATFORM-3-EJECTOR_STAT_CHANGED: Ejectors' status in slot [dec] has changed, [chars] Ejector is [chars], [chars] Ejector is [chars] Explanation Ejector status has changed. Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco Support web site http://www.cisco.com/tac. Error Message PLATFORM-3-MOD_BRINGUP_MULTI_LIMIT: Giving up after multiple attempts were made to bring up the Module [dec], (Serial number [chars]) Explanation The module cannot be powered up even after three attempts. Recommended Action Enter a 'show platform internal all module [decimal digit]' and 'show module internal all module [decimal digit]' 'show sprom xbar [dec] [dec]' to read module IDPROM contents to collect more information. 2-490 Cisco NX-OS System Messages Reference OL-15994-03