HP AP775A Cisco NX-OS System Messages Reference (OL-15994-03, July 2009) - Page 270
FWM-3, Cisco NX-OS System Messages Reference, OL-15994-03,
UPC - 884962062708
View all HP AP775A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 270 highlights
FWM Messages Chapter 2 System Messages and Recovery Procedures Send document comments to [email protected] Error Message FWM-2-STM_LEARNING_RE_ENABLE: Re enabling dynamic learning on all interfaces Explanation Reenabling learning on all interfaces after disable period expired. Recommended Action No action is required. Error Message FWM-2-STM_LIMIT_REACHED: [chars] Explanation The system station table reached its capacity - no further MAC addresses could be programmed - administration intervention may be required to avoid this problem in future. Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco Support web site http://www.cisco.com/tac. Error Message FWM-2-STM_LOOP_DETECT: [chars] Explanation The system detected loops in the network - administration intervention may be required to avoid this problem in future. Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco Support web site http://www.cisco.com/tac. FWM-3 Error Message FWM-2-STM_MCAST_PROG_RE_ENABLE: Re enabling programming multicast entries Explanation Reenabling programming new multicast entries because number of entries reached below threshold. Recommended Action No action is required. Error Message FWM-3-FCFIB_ERR: [chars] Explanation Fcfib has detected an error. Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco Support web site http://www.cisco.com/tac. Error Message FWM-3-FCFIB_NO_MEM: Out of memory Explanation Fcfib does not have enough memory to continue proper operation. Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco Support web site http://www.cisco.com/tac. 2-232 Cisco NX-OS System Messages Reference OL-15994-03