HP AP775A Cisco NX-OS System Messages Reference (OL-15994-03, July 2009) - Page 811
Urib-4
UPC - 884962062708
View all HP AP775A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 811 highlights
Chapter 2 System Messages and Recovery Procedures URIB Messages Send document comments to [email protected] Error Message URIB-3-UFDM_MTSSEND_FAILURE Format: MTS send; to UFDM failed with unexpected error %d Explanation URIB was unable to send a route update to UFDM. This means there will be a route missing from the FIB. Recommended Action Use the 'system switchover' command to switch over to the standby supervisor. If no standby is present, or the standby is not ready, use the 'reload' command to reload the system. The state of the standby can be checked using the 'show system redundancy ha status' command. Error Message URIB-3-XCHECK_ERROR Format: ksink_event_wait 0x%08x returned error %s Explanation This messages are for internal debugging only. Parameters: Memory address, Error ... Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco Support web site http://www.cisco.com/tac. URIB-4 Error Message URIB-3-XRI_TYPE_ERROR Format: Unknown XRI type %u Explanation URIB detected unknown eXtended route information while displaying a next-hop address. Recommended Action No action is required. Error Message URIB-4-INVALID_PIB Format: %s %s Explanation A bad protocol information block was encountered in the given situation. Parameters: Situation, Message ... Recommended Action No action is required. Error Message URIB-4-NH_RESOLV_LUKUP Format: Could not find %s/%d while processing %s (%d) resolve buffer Explanation Unresolved nexthop not cleaned up properly. Recommended Action No action is required. Error Message URIB-4-RTDEL_ERROR Format: Could not find prefix %s/%d, client \%s\sdeleterequest' Explanation Route delete request was received for a non-existing route. Parameters: Prefix, Prefix Length, Client ... Recommended Action No action is required. OL-15994-03 Cisco NX-OS System Messages Reference 2-773