HP Cisco Catalyst Blade Switch 3020 Cisco Catalyst Blade Switch 3020 for HP Co - Page 146
ip igmp profile
View all HP Cisco Catalyst Blade Switch 3020 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 146 highlights
ip igmp profile Chapter 2 Cisco Catalyst Blade Switch 3020 for HP Cisco IOS Commands ip igmp profile Use the ip igmp profile global configuration command to create an Internet Group Management Protocol (IGMP) profile and enter IGMP profile configuration mode. From this mode, you can specify the configuration of the IGMP profile to be used for filtering IGMP membership reports from a switchport. Use the no form of this command to delete the IGMP profile. ip igmp profile profile number no ip igmp profile profile number Syntax Description profile number The IGMP profile number being configured. The range is 1 to 4294967295. Defaults No IGMP profiles are defined. When configured, the default action for matching an IGMP profile is to deny matching addresses. Command Modes Global configuration Command History Release 12.2(25)SEF Modification This command was introduced. Usage Guidelines When you are in IGMP profile configuration mode, you can create the profile by using these commands: • deny: specifies that matching addresses are denied; this is the default condition. • exit: exits from igmp-profile configuration mode. • no: negates a command or resets to its defaults. • permit: specifies that matching addresses are permitted. • range: specifies a range of IP addresses for the profile. This can be a single IP address or a range with a start and an end address. When entering a range, enter the low IP multicast address, a space, and the high IP multicast address. You can apply an IGMP profile to one or more Layer 2 interfaces, but each interface can have only one profile applied to it. Examples This example shows how to configure IGMP profile 40 that permits the specified range of IP multicast addresses: Switch(config)# ip igmp profile 40 Switch(config-igmp-profile)# permit Switch(config-igmp-profile)# range 233.1.1.1 233.255.255.255 You can verify your settings by using the show ip igmp profile privileged EXEC command. 2-118 Cisco Catalyst Blade Switch 3020 for HP Command Reference OL-8916-01