HP Cisco Catalyst Blade Switch 3020 Cisco Catalyst Blade Switch 3020 for HP Co - Page 479
spanning-tree mode
View all HP Cisco Catalyst Blade Switch 3020 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 479 highlights
Chapter 2 Cisco Catalyst Blade Switch 3020 for HP Cisco IOS Commands spanning-tree mode spanning-tree mode Use the spanning-tree mode global configuration command to enable per-VLAN spanning-tree plus (PVST+), rapid PVST+, or multiple spanning tree (MST) on your switch. Use the no form of this command to return to the default setting. spanning-tree mode {mst | pvst | rapid-pvst} no spanning-tree mode Syntax Description mst pvst rapid-pvst Enable MST and Rapid Spanning Tree Protocol (RSTP) (based on IEEE 802.1s and IEEE 802.1w). Enable PVST+ (based on IEEE 802.1D). Enable rapid PVST+ (based on IEEE 802.1w). Defaults The default mode is PVST+. Command Modes Global configuration Command History Release 12.2(25)SEF Modification This command was introduced. Usage Guidelines The switch supports PVST+, rapid PVST+, and MSTP, but only one version can be active at any time: All VLANs run PVST+, all VLANs run rapid PVST+, or all VLANs run MSTP. When you enable the MST mode, RSTP is automatically enabled. Caution Changing spanning-tree modes can disrupt traffic because all spanning-tree instances are stopped for the previous mode and restarted in the new mode. Examples This example shows to enable MST and RSTP on the switch: Switch(config)# spanning-tree mode mst This example shows to enable rapid PVST+ on the switch: Switch(config)# spanning-tree mode rapid-pvst You can verify your setting by entering the show running-config privileged EXEC command. OL-8916-01 Cisco Catalyst Blade Switch for HP Command Reference 2-451