HP Cisco Nexus 5000 Cisco Nexus 5000 Series Switch CLI Software Configuration - Page 484

Configuring Type Network QoS Policies Configuring System Classes Command or Action Purpose The three policy-map configuration modes are as follows: • network-qos-Network-wide (global) mode. CLI prompt: switch(config-pmap-nq)# • qos-Classification mode; this is the default mode. CLI prompt: switch(config-pmap-qos)# • queuing-Queuing mode. CLI prompt: switch(config-pmap-que)# Step 3 Step 4 Step 5 switch(config)# no policy-map [type {network-qos | qos | queuing}] policy-name (Optional) Deletes the specified policy map. switch(config-pmap)# class [type Associates a class map with the policy map, and enters {network-qos | qos | queuing}] configuration mode for the specified system class. The three class-name class-map configuration modes are as follows: • network-qos-Network-wide (global) mode. CLI prompt: switch(config-pmap-c-nq)# • qos-Classification mode; this is the default mode. CLI prompt: switch(config-pmap-c-qos)# • queuing-Queuing mode. CLI prompt: switch(config-pmap-c-que)# switch(config-pmap)# no class [type {network-qos | qos | queuing}] class-name Note The associated class map must be the same type as the policy-map type. (Optional) Deletes the class map association. Configuring Type Network QoS Policies Type network qos policies can only be configured on the system qos attachment point. They are applied to the entire switch for a particular class. Procedure Step 1 Step 2 Command or Action switch# configure terminal Purpose Enters configuration mode. switch(config)# policy-map type Creates a named object that represents a set of policies that network-qos policy-name are to be applied to a set of traffic classes. Policy-map names can contain alphabetic, hyphen, or underscore characters, are case sensitive, and can be up to 40 characters. Cisco Nexus 5000 Series Switch CLI Software Configuration Guide 438 OL-16597-01