HP Cisco Nexus 5000 Cisco Nexus 5000 Series Switch CLI Software Configuration - Page 598

Configuring the Default Zone Access Permission Configuring and Managing Zones The default zone members are explicitly listed when the default policy is configured as permit or when a zone set is active. When the default policy is configured as deny, the members of this zone are not explicitly enumerated when you view the active zone set. Configuring the Default Zone Access Permission To permit or deny traffic to members in the default zone, perform this task: Procedure Step 1 Step 2 Step 3 Command or Action switch# configuration terminal Purpose Enters configuration mode. switch(config)# zone default-zone permit vsan Permits traffic flow to default zone vsan-id members. switch(config)# no zone default-zone permit Denies (default) traffic flow to default zone vsan vsan-id members. About FC Alias Creation You can assign an alias name and configure an alias member using the following values: • pWWN-The WWN of the N port is in hex format (for example, 10:00:00:23:45:67:89:ab). • fWWN-The WWN of the fabric port name is in hex format (for example, 10:00:00:23:45:67:89:ab). • FC ID-The N port ID is in 0xhhhhhh format (for example, 0xce00d1). • Domain ID-The domain ID is an integer from 1 to 239. A mandatory port number of a non-Cisco switch is required to complete this membership configuration. • Interface-Interface-based zoning is similar to port-based zoning because the switch interface is used to configure the zone. You can specify a switch interface as a zone member for both local and remote switches. To specify a remote switch, enter the remote switch WWN (sWWN) or the domain ID in the particular VSAN. Tip The switch supports a maximum of 2048 aliases per VSAN. Creating FC Aliases To create an alias, perform this task: Procedure Step 1 Command or Action switch# configuration terminal Purpose Enters configuration mode. Cisco Nexus 5000 Series Switch CLI Software Configuration Guide 552 OL-16597-01