HP DL560 ProLiant DL560 Server Maintenance and Service Guide - Page 17
Extending the Server from the Rack, Grasping the handles on the front bezel
UPC - 808736876919
View all HP DL560 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Removal and Replacement Procedures 17 5. If the server is installed in a rack, locate the server by identifying the illuminated rear UID LED button. 6. Disconnect the power cords. The system is now without power. Extending the Server from the Rack 1. Loosen the thumbscrews that secure the server faceplate to the front of the rack. 2. Grasping the handles on the front bezel, extend the server on the rack rails until the server rail-release latches engage. WARNING: To reduce the risk of personal injury or equipment damage, be sure that the rack is adequately stabilized before extending a component from the rack. WARNING: To reduce the risk of personal injury, be careful when pressing the server rail-release latches and sliding the server into the rack. The sliding rails could pinch your fingers. 3. After performing the installation or maintenance procedure, slide the server back into the rack: